The Wilson Glass Mount Outperforms the Competition
Up to 90% of a cellphone's power on transmit and receive
is absorbed within a vehicle and the users head. We solve this problem
by channeling all the power from the cellphone to the outside antenna.
This results in our glass mount antenna transmitting and receiving over
10 times the signal of a cellphone used inside a car / truck without an
outside antenna.
The Wilson Glass Mount Cellular Antenna was carefully designed to minimize loss and maximize gain on both the 800 MHz and 1900 MHz bands. Wilson accomplished this by using a phasing coil and a low loss coaxial phase reversing device that provides high gain on both frequencies. Wilson's innovative design results in high efficiency with low losses and will get the most signal to your cellular phone. Thanks to these innovations and our attention to detail Wilson Electronics has the best performing glass mount cellular antenna available.
Usage
The Wilson Glass Mount Cellular Antennas main benefit
over our other dual band antennas is its ability to pass its signal through
single pane glass. This allows for very clean looking permanent installations
in which the cable is hidden.
Specifications:
Electrical Properties:
Part #........................301102
Frequency Range.....806-894 MHz
.....1850-1990 MHz
Impedance..................50 Ohms / Both Bands
Antenna Gain.............4.5 dBi 806 - 894 MHz
..............5.9 dBi 1850 - 1990 MHz
System Gain...............10-15 dB (More Than 10 Times the Signal)
of a cellphone
................used inside a car / truck without an outside antenna.
Radiation....................Omni
Polarization................Vertical
Wavelength.................1.1 Wavelengths 806-894 MHz
...............2.3 Wavelengths 1850-1990 MHz
Ground Plane.............Built in Ground Plane
Mechanical Properties:
Connector.....................FME-Female
Material......................Whip - Stainless Steel
Coax Cable.................RG58 / 14'
Height..........................15"
Mount..........................Glass Mounting with 3M Adhesive